NORSOK M-101 is revised
A new version of NORSOK M-101 Structural steel fabrication is published. This is revision 6 of the standard.
NORSOK M-101:2024 “Structural steel fabrication” was published on April 3rd 2024.
Main changes
NORSOK M-101:2024 “Structural steel fabrication” is revised by the expert group SN/K 114 NORSOK EG M Materials.
The main changes from rev. 5 are an update of the technical content based on experience, new requirements and new international standards and the implementation of two new annexes with general requirements for structural bolting in the execution of structural steelwork as structures or as fabricated components annexes.
- NORSOK M-101:2024 covers the requirements for fabrication and inspection of offshore steel structures with SMYS < 500 MPa and with a minimum design temperature down to -10 °C (non-Arctic), -20 °C (Arctic 1), -30 °C (Arctic 2) and -40 °C (Arctic 3).
- NORSOK M-101:2024 ensures safe quality for up to 50 years design life for offshore platforms, jackets, topside modules for FPSO and other floaters, subsea production system structures and minor structures.
- Special structure application where higher SMYS is needed shall be handled outside NORSOK M-101:2024.
- Annex H and Annex I defines the general requirements for structural bolting in the execution of structural steelwork as structures or as fabricated components.
- Annex H and Annex I are valid for thread sizes M12 to M72 mm and for property classes 8.8 and 10.9.
- For stainless bolts Annex H and Annex I are only applicable for thread sizes M12 to M39 mm and for property class A4-80. Sizes greater than M24 for property class A4-80 might not be available as bolt and nut assemblies.
- Annex H and Annex I do not cover anchor bolts and welded bolting assemblies.
- Excluded from the scope is also bolting for SPS (Subsea Production Systems) and SURF (Subsea Umbilical's Risers Flowlines).
Questions and contact:
For further detail please contact project manager in Standards Norway,
Espen Holm